What's your E-flite Pwr 110 Motor setup

Like the title says, I'm looking for successful ESC/Prop setups for this motor. I've got one in my Seagull Yak 54 with a CC HV-85 ESC but cause of software issues, I can't use the power that this motor should provide

I've tried all the newest CC updates and all the different settings (currently using PWM of 8khz, timing of 3 and lower) but nothing stops the dreaded timing issue whenever I go higher than ~3/4 throttle.

The Yak 54 comes in at 9.9lbs, desired props in the 17x8 - 18x10 range, 8S 4000mah packs of which some are 20C, 25C and 30C.

I've been able to fly her with a 16x10 prop but if I try to pull out of a hover or even push to hard on take-off, i get that loud motor screech and loss of power. The good thing is if I back off the throttle, the timing will correct but that takes 3D out of the question.
View complete forum thread


Related threads

Power System for the New E-Flite Sukhoi SU-26m 480 ARF

... put together an ideal Common Sense RC power system for the new E-Flite Sukhoi SU-26m 480 ARF. E5-L-13 Brushless Outrunner Motor Z-35 ESC - 35 Amp 11.1 volt - 2200mAh 35C Li-Poly Pack APC Propeller - 10x5 E This power system can also be used for the E-Flite RV-9 450 ARF and the E- ...

3 ESCs in parallel with 1 battery..help

I am trying to solve a power dilemma for a 3 60A esc and 3 motor setup. I will be ... I was ever drawing from my battery was 10amps and this was usually on start up of the motor. After a few seconds the current would drop down to about 3.5 amps. Does this mean that at any given time my batteries should ...

E-flite Park 400 motor for 3D?

I've run an E-flite Park 400 motor on several different planes with various esc's and am ... the same feel as a worn out brushed motor. Just tired. The motor has about 100 flights on it. I have a comparable Common Sense 1000 kv motor which has twice the thrust and about the same amount of flights. Is ...

Anyone had success with eflite pwr 110 and 3.00 firmware

... really hoped that this latest beta would be the cure all but unfortunately it's not. I'm running a Pwr 110 with 17x10 prop on 8S. I'd really like to run a 18x10 but anything over 1/2 throttle equals total motor pinging whereas with a 17x10 I can at least get to ~80% throttle but still can't punch ...

Discussion 1/9th scale Anderson Kingfisher

... . Here are the proposed specs span: 48.66 length: 31.33 height: 10.66 wing area: 317.33 Proposed power I am planning an e-flite 370 1360kv motor max esc 40a Prop size will be 8" Estimated weight should be around ...

HYPERION HELIOS 10e servo recommendation and other questions.

... wondering what other owners recommend as far as servos to use. Would the Hitec HS-55 or Futaba S3114 be powerful enough? I was going to use a Scorpion motor setup but decided to go with ... Hyperion Z2213-16 brushless outrunner and a Titan 20A ESC power set to simplify setup. Any ...

Windrider new Su-29 molded EPP acrobatic

... 736 sq'ft' Wing loading: 7.67 oz/sq'ft' Radio: 4 channels Servo: 3 pcs of Futaba #3107 ESC: 20 amp Power system: Speed 380 with gear box or BL motor setup Battery: 8.4V to 9.6V or Lipoly 2 to 3 cells Su-29 movie (3.6 MB) Photos:

Alfa Mig-15 Brushless questions...

I just ordered the Alfa Mig and have a couple questions about the power system...? I have an extra Astro 020 803 motor setup - will this work in this jet -and- can I use my 8 cell Nimh 1800 batteries instead of the liPoly...? Does the belly need ...

By George I think they got it RIGHT!

Long story short, I've been using CC HV-85 with Eflite Pwr 110 motor, 18x10E prop, various 8S 3700-4000mah 25-35C packs and I (like so many others) have been suffering the same timing issues/frustrations over the last 6 months or so. Well ...

How to calibrate Throttle range

So I'm using using Firmware 2.16 with 3.22 castle link with my HV85 and Eflite Pwr 110 motor on 8S, 16x10 prop and I notice full throttle gets me ~ 2100 watts but mid throttle is only ~ 300 watts. So I recall my DX7 to the HV85 by: 1. Program ...

Discussion Giant you-can-do to brushless

Hi, all here is my u-can that I have had for 3 years on a O.S.1.60 and it was very fun... But now!! it has more then 2 times the power now!!:eek: Giant-U-Can-Do with Brushless Motor Setup "maiden flight" (3 min 51 sec)

E-Flite Six series makes the power!

... have this motor in my Stryker. The E-flite motor and the Stryker make a crazy fast combo. ... 90-100 mph with a 6x4 prop. Anyway I hooked up my Power meter to see how may Amps ,watts ect my ... making 630 Watts of power and pulling 53 amps. I was surprized. I motor doesnt even get that hot in flight. The ...

Range/interference problem with E-flite Power 110 Brushless and Phoenix HV-85

My power system consists of an E-flite Power 110 brushless outrunner, Phoenix HV-85 ESC and 9s, 6000maH Lipo ... braided or held together to reduce interference. This setup has reduced my range test with ... paces, after which the servos start glitching and motor control is erratic. I shielded all ...

Mystery power failure on E-Flite F15

... bought two Phoenix 60a ESC's for use in a new E-Flite F15 Ducted Fan ... ProdID=EFL7050 This is my power setup: Two Don's RC Wicked Extreme motors: http:// ... servos on the elevators, connected with Y-lead to RX Two E-flite sub-micro servos on the ailerons ... Grayson Hobbies 40A E-Flite 60A Phoenix L 12.36V ...

Comparing two Brushless motors (AXI 2826/8 vs. E-Flite Power 25)

... forum. Can you help? I'm trying to decide between the two motors. I'm comparing the Axi 2826 and the E-Flite Power 25. ... compare everything. However, when looking for reviews on the net, I was not able to find anything comparing these two motors. Since, I'm new to brushless electric, I can't rely on ...

E-Flite 110 Motors break down at high Watts on my controllers, please advice

... success and no problems. But I now ran into severe problems with my 3 E-Flite 110's that I just bought. And one of them died a ... startup etc...in order to figure out whats going on. only ran the motor for a second or two at a time....still got the better of me Regarding controllers: I experience ...

E flite Beaver

Hi All I'm looking for a power system & battery for an E flite Beaver. E flite recommends a power 25 or a 32 for this plane.. http://www.horizonhobby.com/Products...32A#quickSpecs I would like to go with the 32 but with a Hyperion or a Scorpion system.. Thanks Dan

E-flite esc problems...

I just bought a new 10 amp brushless E-flite esc to go with my power set up for ... the esc is not being consistent arming the e-flite 250 brushless motor. It seems to be hit and miss ... can't figure out why the darn thing won't arm the motor every time. I have had it running then I disconnect the battery ...

e-flite 400 outrunner/thunderbird 18 esc question

I have an e-flite 400 brushless outrunner in my Goldberg surge 400. I am using the ... . Today, on start up, all control surfaces worked as per usual, but the motor now runs backwards. What in the world would do this? Of course I suppose I can switch two of the motor power wires and reverse it, but why ...

What power system

... figure out which brushless power system I should replace the stock 550 can motor and 25amp esc ... flights but the airplane flies like a dream, the power system sucks though. I tried it with an 8 cell 800mah ... lipos and a 20 amp brushless esc. I was thinking of an e-flite 370 outrunner with like a 9x6 ...

I wanna go fast: E-Flite 60, Hacker A50 16S or TowerPro 4130-7 ?

... glow conversion, and like Ricky Bobby from Talladega Nights, I wanna go fast! For the power system, my current thinking is a 60 size motor, like: TowerPro 4130-7 Hacker A50 16S E-Flite 60 I am thinking to run this along with an 8S1P A123 pack and an APC 14x12E ...

need motor mount idea for Eflite Power 110

I need a motor mount for the E-Flite Power 110 motor Whats a good one that will fit that motor? I bought the ElectriFly brushless motor mount for extra large motors and the Power 110 is too wide for the mount. I guess the 110 is XXL Any good ideas? thanks Ken

Extreme 5 Susceptability to Power Lines

... . now I am thinking it was EMI due to a high voltage power line. Anyone experienced in rcvrs ... at about 30 yards and not worsening with the motor running at idle (didn't do it w/ full power). The Projeti ... (note I get the same level of chatter pwr on and off. Before I write this crash off as pilot ...

E-flite motors - Where do they get their numbers???

... put together a spreadsheet with all of the different stats on different motors in it so when I need a power system, I can just pull up the spreadsheet and pick one. (I'll share ... many peak watts per $ Now when doing this I've noticed things on Horizon's website, like the E-flite Park 450 motor for ...